Ei Electronics EI105C Manual de usuario descargar pdf (Pagina 6)

(b) Connecting the battery

The battery is easily removed from the holder by holding back

one of the plastic clips while lifting the battery with the other

hand.

Snap Battery Connectors to Battery. They fit together only one

way.

Gently push Battery into Battery Holder

With a pencil, write the date of battery installation on the inside

of the cover to remind you when to replace the battery.

To close the cover match up snap-in hinges and gently press

together until base and cover snap together. Test the installed

Smoke Alarm - see section “Manually Testing your Smoke

Alarm”.

NOTE: You may hear a loud chirp when attaching the Battery

Connectors to the Battery.

Battery Missing indicator

Some models are fitted with a warning flag which pops up when

the battery is removed. This prevents the cover from closing

when there is no battery in the unit. When the battery is being

installed or changed, this flag must be held down while gently

pushing the Battery into the Battery Holder. (Figure 7(a)).

Looking after your Smoke Alarm

(a) Automatic Self-Test

The smoke chamber automatically tests itself every 40

seconds. If the chamber is degraded it will beep without

the

LED flashing at the same time. If this happens clean the unit. If

the beeping persists and the beep does not coincide with an

LED flash, return the unit for service (see “Getting your Smoke

Alarm Serviced”).

B10274-R4-105B-U&C-ENG 30/9/09 8:23 AM Page 6

1 2 3 4 5 6 7 8 9 10 11 12 13 14

Sin comentarios

Ei Electronics EI105C Manual de usuario Pagina 6