Ei Electronics Ei3103RF Manual de usuario

ProfessionalModel: EI17ORFRadioLiNStrobe & Vibration Pad ModuleFor use with RadioLlNK Smoke/Heat/Fire Alarms(Smoke / Heat / Fire Alarmsupplied sep

The Ei170RF is for use with the following Ei RadioLINK Smoke/Fire/Heat Alarms and Accessories.Mains Multisensor/Smoke/Heat/Fire Alarms:Ei2110, Ei160RC

Figure2Plug the battery into the socket at the rear of the battery compartment as shown in Figure 2 (whileholding the small latch on the battery plug,

Ifconnectingto a mains Junction BoxIt is preferable to permanently wire the unit into a mains junction box. In this case remove theplug and wire as fo

liFigure43.1.6If some units flash less than the expected number of times, after being in House Code Mode forover 10 minutes) (say four times on a six

4.1 AFTER INSTALLATION4.1.1Check that all RadioLINK Alarms and Accessories are powered correctly.4.1.2Check that the green light on the Ei17ORF Strobe

the battery will need to be replaced. Contact the nearest address in this leaflet for advice about gettinga replacement. The battery also needs to be

Ei428 - RadioLINK Relay Module:This module contains a set of relay contacts that switch uponreceipt of an alarm signal from suitable RadioLINK Smoke/F