Ei Electronics Ei3103RF Manual de usuario descargar pdf (Pagina 3)

Figure

Plug the battery into the socket at the rear of the battery compartment as shown in Figure 2 (whil

holding the small latch on the battery plug, open)

. Place the battery in the compartment ensuring th

notch in the battery is used to leave clearance for the plug and sockets (see Figure 3)

Batter

Clearanc

Notc

Figure

Shows battery orientation - Dress the battery leads as shown, replace the battery cover an

push firmly down on the two latche

The Strobe Module can be left on a table or permanently fixed to the wall using the screws and plasti

plugs enclosed

If fixing to a wall, the screws should be spaced 95mm (3

.7 inches) horizontally apart

. The top screws wi

be 70mm (2

.7 inches) below the top surface of the Strobe Module when installed

. The template at th

end

of this leaflet can be used to locate the screws accurately

. The screws (large heads) should b

screwed into the wall leaving a gap of approximately 4mm (O

.15in) under the head

. Fit the keyhole slot

;

on the back of the Strobe Module over the screw heads and slide the panel down vertically into positio

The mains adaptor should then be- plugged into a socket (or permanently wired to a mains junction bo

- see overleaf)

. This mains socket must not be used for any other equipment and it must not be switche

off

. The mains plug

. must be readily removable (so the mains can be disconnected if necessary)

1 2 3 4 5 6 7 8

Sin comentarios

Ei Electronics Ei3103RF Manual de usuario Pagina 3